WTB: Cat-back for 87is (PNW)

[BKC]

Time for a new muffler. Car production date is June. Located in Washington state.

[browntown]

I'm not sure what the 87is takes, but I bought an Ansa catback for my 89i that is now useless to me with the m90 swap (I'm going to have to do a custom exhaust)

I'd sell it reasonably, I bet it has less than 1000 miles on it. Problem is that I am a very long drive from Anacortes.

[BKC]

I'm not sure that would fit. I also see that I posted this in the wrong section. What a rookie mistake.

[Pocket Chant]

All 325 exhausts are the same, it'd fit.

[MR 325]

All 325 exhausts are the same, it'd fit.

No, but all M20B25 325i/ic/is exhausts are the same.

[BKC]

Then I'm confused because Pelican's site says that there are two different cat-backs for 87, one that they show for September on and one that they don't show for cars made prior to that. Unfortunately, of the two people that I've talked to there, one was not very nice and the other was a Porsche guy who didn't know squat.

[MR 325]

You can trust my info. ;)

[BKC]

Screw it. I think I'll get the Remus from Bavauto. Sounds nice but not obnoxious.

[BKC]

Well, maybe not. They're out of stock until October 31.

[BKC]

Anyone know if you can slip chrome tips over the Eberspaesher? The tips look too close together in the pics that I've seen.