WTB: M20 Single-mass Flywheel ASAP!

[jbruch694]

I am in the middle of a clutch project I need to finish before early January and upon taking out my flywheel and measuring it to go get it resurfaced, I found out it is below spec, at 1.220" where it should be 1.260." Can't afford to buy new, anyone have one laying around that is machined or has enough meat left on it to be remachined?

Thanks, JB

Edit: I am near Bethesda, MD

[20gmr]

I have one here just outside of hershey machined and ready to go

[jbruch694]

PM sent