If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ok, before I waste a trip to Concord and buy one from the eurodepot, anyone else have an abs half shaft for an 87 es? I need one to finish the car I sold.
I have em' and not as far north as ED. There just not out yet and I'm trying to think if I can pull it w/ out screwing w/ the hub,( I think I can) One from the 88' iS' should work, right??
Send me a PM or call me Scott.
I have em' and not as far north as ED. There just not out yet and I'm trying to think if I can pull it w/ out screwing w/ the hub,( I think I can) One from the 88' iS' should work, right??
Send me a PM or call me Scott.
I dunno man - I tried getting the ones off the red car (the one we picked up from Framingham yesterday) and we broke a half inch breaker bar. I may just grab one from them to make things easier...
I can come down Friday evening round 7:00-7:30pm if ya want.
you broke a 1/2" breaker bar..?? Wtf?? probly is easier to grab one from ED.
Is that for the pass. side??
I can come down Friday evening round 7:00-7:30pm if ya want.
you broke a 1/2" breaker bar..?? Wtf?? probly is easier to grab one from ED.
Is that for the pass. side??
I'll be there most of the day tomorrow cleaning up, getting the blue car finito.
The 1/2" breaker bar was a Duralast, guaranteed for life - so I'll get another one. I then moved on to a 1/2" drive Crafstman rachet with extension - the extension broke. But yeah, trying to get the axle nut off just wasn't happening. It got to the point that the wheel was spinning instead of the nut, and Matt was on the brakes, the car was on the ground, and the brakes are new. WTF.
We'll be shooting up to Concord tomorrow, unless the brake problem that's just developed in my Jeep is worse than I think it is. We'll see in the AM. Any chance you can make it over there or no?
Scott I have tons of stuff if you ever get in a jam like that again....same goes for you wastedincome.
I do too - but some parts (like the half shaft) don't like coming off. Or like tonight, where we had to drive an hour to Milton to get a hub, because I couldn't get one off the bronzit car, even though it's on it's fucking roof. argh.
I do too - but some parts (like the half shaft) don't like coming off. Or like tonight, where we had to drive an hour to Milton to get a hub, because I couldn't get one off the bronzit car, even though it's on it's fucking roof. argh.
When's you birthday Scott, I'm buying you a "real mans hammer" A BFH goes a long ways...lmao...Sorry it was so fuggin cold. And the 12"+ of snow made for a fun adventure. If ya had called me earlier in the day ya wouldn't have been so stressed, But all in all ya made good timing finishing it all up..
BTW: Is that new owner gonna end up a member here??? That would be funny
Atleast now I can pull half shafts, hubs, and bearings in my sleep
Comment