WTB 325i or super eta intake .

[tn325i]

I am doing some engine work, I started out with an eta engine.. I'm replacing the head with a 323I head and I need a better flowing intake to go with this setup..

I had one for $45 but for some reason the guy quit answering emails.. Oh well..

Can anyone help me out ?

Thanks,
Steve

[SchnellerVert]

What about Rigmaster, or Ely. RS4PRO he's in TN too.

[tn325i]

Ely is the one helping me with the motor work.. He didn't have a spare intake laying around..

[rs4pro3]

I believe Rigmaster has some, as I was going to buy one from him.

[Mitch M]

Re

I have an i just across the mtn I'll sell for that.

[h0lmes]

Sent you a pm.

[mattdk318i]

Mitch has one in the FS section

[Rigmaster]

I've got a couple- but just to clarify, you do NOT want the Super Eta intake manifold- it's got even smaller diameter runners than the eta intake.




Bret.

[rs4pro3]

well this isn't going onto an I head. It's going onto a 731 Euro head. I think the small runners would help with the torque

[Funkmasta]

I have a few, can do $60 shipped, ready to go out tomorrow.
Let me know, Joe

[Mitch M]

Re:

well this isn't going onto an I head. It's going onto a 731 Euro head. I think the small runners would help with the torque

DO NOT ruin that head w/ a SETA intake. The plenum is tiny as well. Use an i or a 323

[tn325i]

Thanks for the replies...

I didn't clarify that I also need the throttle body.. So a I intake or better a 323 intake. Best offer I have so far is $45.. Some one closer to me could save me some shipping.. I'm close to Chattanooga Tn.

[Sean]

I have a supereta intake I'd let go for like $30 + shipping?

But, sounds like you don't need it or want it rather. lol

[tn325i]

Thanks everybody, I found what I needed..

Steve

[SchnellerVert]

See networking helps.