If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
WTB Used 84mm bore stroker pistons for an M20 2.7 stroker motor. Looking for pistons that work with the 89 325i head and ETA rods, and have compression ratios in the 9-10 to 1.
Have a set of SETA pistons. Mill ~0.020" from the head or a little less from the block or both and you have a 9.0:1 2.7. I've personally milled 0.018" off an i head....38.5cc.
Comment