S50

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • blackjackT7
    Member
    • Jun 2015
    • 49

    #1

    S50

    looking for an S50, dropped a valve in mine and need a replacement. I have all the accessories so I really just need a long block, but open to anything at this point.
  • GUERONASTY
    E30 Modder
    • Aug 2011
    • 811

    #2
    Not mine just something I ran into

    Used (normal wear), From a 1995 M3 Used for Bmw e30 3 series swaps 150k Comes with block, crankshaft, pistons, and connecting rods. Recommend honing/replacing bearings and piston rings before assembly. Also have other engine parts as well for 1993-1999 bmw 3 series motors. The reason it’s dissembled is because cylinder head was removed for a port job and never went through with it. Did not have blown head gasket or any mechanical failure. Was a perfectly running motor. $800 picked up. Make an offer!;

    Comment

    • blackjackT7
      Member
      • Jun 2015
      • 49

      #3
      I would be all over that if they were willing to ship. Thanks for the lead!

      Comment

      • dude8383
        Forum Sponsor
        • Jan 2005
        • 10387

        #4
        i've got an S50 that needs a rebuild. asking $1k for the lot (plus shipping). i gotta yank the head off of it to confirm if a valve broke or if the bottom end needs the rebuild. we pulled it because # 6 had super super low compression. sounded like a bad valve.
        IG: deniso_nsi Leave me feedback here

        Comment

        • blackjackT7
          Member
          • Jun 2015
          • 49

          #5
          Thanks for the help guys I found one.

          Comment

          Working...