WTB: Pass control arm

[Hick]

Anyone have a pass side control arm laying around? The inner ball joint on the bronzit is toast [has been making noise for a while] I dont have the money to buy a new one right now but can pay a little plus shipping if anyone would be so kind as to give a poor sap from ohio a hand out.

[Mike325]

Anyone have a pass side control arm laying around? The inner ball joint on the bronzit is toast [has been making noise for a while] I dont have the money to buy a new one right now but can pay a little plus shipping if anyone would be so kind as to give a poor sap from ohio a hand out.

I can sell you two (inner and outer) ball joints for $55 shipped. Brand new.

[Hick]

I was under the idea that factory control arms were not able to have ball joints pressed in. Only the outers could be replaced.

[Jand3rson]

I've got one from a car that only had 119k miles, both of the ball joints still have intact boots and very good movement. Has a good control arm bushing and bracket, also.

FedEx Ground would run about $20, so think you could swing $40 total?

[Jand3rson]

*BUMP*

Do you still need this? I sent a PM.