WTB: M20B25 or Head

[jamiholzbach]

I just ordered a new timingbelt, and before it could get here, SNAP!
So, I'm looking for an "i" motor with less than 170k on it, or a good runner,
or an "i" head. I don't have alot to spend, and it may take a little while to put funds together (poor grad student). Any response is welcome as my feet are already getting sore and tired.

[MA325is88]

I have an i head, 300 shipped.

[emi325i]

http://www.r3vlimited.com/board/showthread.php?t=95817

I think he might still have it.

[ColdAccord]

i have a complete euro m20b25 (little bit higher compression ratio, tad bit more power). 99k on it, no problems whatsoever. doesn't leak a drop, nor burn anything. $1k. or I have a worked head. had 65k on it before machinework was performed. milled, cleaned, 3 angle valve job, new valve seals, valves re-seated. $495. PM me if interested in any

[jhower08]

I have a complete "I" engine with 120k on it, new timing belt, water pump, plugs, cap, rotor, and oil pan gasket. Yours for $500. PM me if interested.