Ok Im thinking of running a whole new setup on my car this time around so I kinda want to get a feeler going to see what I can get for this setup before I even decide on selling.
So the info on the setup is OBD2 headers that have been welded and the front header was cut shorter to avoid hitting the sway bar.
The headers have been heat wrapped as well.
Coming from each header is a 2 inch pipe going into a Y pipe right before the trans brace. From the Y pipe is a single 2.5 inch pipe into a magnaflow high flow cat and from that it runs into a flowmaster 40 series muffler.
The whole system is mandrel bends and fully welded other then where it bolts to the headers.
The only photos I have are of the headers. I will grab a few when I put the car up on the lift to pull the exhaust off.
I would like for this to be pick up only since it is all one piece.
Pick up will be in Williamsport, Pa 17701
I would like to see atleast 600 from this.. Has less then 1000 miles on it.
Heres 2 little video clips that I have.
So the info on the setup is OBD2 headers that have been welded and the front header was cut shorter to avoid hitting the sway bar.
The headers have been heat wrapped as well.
Coming from each header is a 2 inch pipe going into a Y pipe right before the trans brace. From the Y pipe is a single 2.5 inch pipe into a magnaflow high flow cat and from that it runs into a flowmaster 40 series muffler.
The whole system is mandrel bends and fully welded other then where it bolts to the headers.
The only photos I have are of the headers. I will grab a few when I put the car up on the lift to pull the exhaust off.
I would like for this to be pick up only since it is all one piece.
Pick up will be in Williamsport, Pa 17701
I would like to see atleast 600 from this.. Has less then 1000 miles on it.
Heres 2 little video clips that I have.
Comment