selling my used jl audio 250 watt rms amplifier. the amp is rated at 12.5 volts unlike others that are rated at 14.4 which is a relatively unrealistic voltage rating for the average car running on a stock electrical system, which is why this is true 250 watts. It is working perfectly fine. 914-319-seven eight eight eight. call or text
* Rated Power: 250 W RMS @ 1.5 ohm-4 ohm (11V-14.5V)
* THD at Rated Power: <0.05% @ 4 ohm
* S/N Ratio*: >95dB below rated power
* Frequency Response: 5 Hz - 500 Hz (+0, -1dB)
* Damping Factor: >500 @ 4 ohm/50 Hz
* Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS
* Dimensions: 10.25"L x 9.25"W x 2.36"H
* Differential-Balanced Input Topology: (1 pair of inputs)
* On-board Crossover: fully-variable (40-200 Hz), selectable-slope LP (12 or 24 dB per octave)
* Preamp Output: 2-channel (full-range, LP or HP)
* Bass EQ: variable boost up to 15dB
* Infrasonic Filter: defeatable 24dB/octave at 30 Hz
* Signal-Sensing Turn-On: permits operation without remote lead
* Dual mono speaker output connections: accept up to 8ga. wire
* +12V and Ground connections: accept up to 4ga. Wire
* Rated Power: 250 W RMS @ 1.5 ohm-4 ohm (11V-14.5V)
* THD at Rated Power: <0.05% @ 4 ohm
* S/N Ratio*: >95dB below rated power
* Frequency Response: 5 Hz - 500 Hz (+0, -1dB)
* Damping Factor: >500 @ 4 ohm/50 Hz
* Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS
* Dimensions: 10.25"L x 9.25"W x 2.36"H
* Differential-Balanced Input Topology: (1 pair of inputs)
* On-board Crossover: fully-variable (40-200 Hz), selectable-slope LP (12 or 24 dB per octave)
* Preamp Output: 2-channel (full-range, LP or HP)
* Bass EQ: variable boost up to 15dB
* Infrasonic Filter: defeatable 24dB/octave at 30 Hz
* Signal-Sensing Turn-On: permits operation without remote lead
* Dual mono speaker output connections: accept up to 8ga. wire
* +12V and Ground connections: accept up to 4ga. Wire
Attached Files
