15" Fittipaldi's with Brand New Tires.

[asuj158]

Local offer for 450, beat it and you have a new set of wheels

I bought theses fittipaldis a couple months ago but never mounted them to the car. They are all in pretty good condition and are all pretty straight. One had a bend when I recieved it and I had it professionally straightened. Some of the paint is chipping but they all look decent. Only one has curb rash as shown in the pictures. I also have brand spankin new Nitto Gen. tires, 205/50R/15 NOT ONE MILE ON THEM. Im asking price drop 600+shipping for both OBO.

[matias88e30]

dammnn.. i sold mines for 250 with good tires. good luck

[asuj158]

dammnn.. i sold mines for 250 with good tires. good luck

ok well these tires are brand new and the wheels are in pretty decent condition. thanks for the info though

[trackjunkie21]

Pics mounted on car? and just to let you know 650 is way too much.

[asuj158]

Pics mounted on car? and just to let you know 650 is way too much.

I never had them mounted on the car, sorry:(, well if you think its too much make an offer you think is reasonable. If people are having apaplexy then ill lower the price later.

[Rodoni]

I had a set of these...the center bore was too small for an e30. The CB was 56.1, OP can you measure it?

[asuj158]

I had a set of these...the center bore was too small for an e30. The CB was 56.1, OP can you measure it?

yea sure.

[Rodoni]

edit, yea mm

[asuj158]

ok im kinda a newb. How do I properly measure center bore?

[ck_taft325is]

Metric ruler? I believe it's easier to get a "mic" (Sextant type tool) and push both arms to the inside diameter of the hub bore, then lock each arm (two thumb screws to secure the position) and then put up against a metric ruler.

If it's to small, a ruler would work well as anything below 57.1 is non-functional for direct bolt up on an e30.

Hope that helps some...

[asuj158]

ok well I just measured a stock bottle cap and the wheel and they were both about 32mm across I have to be doin this wrong.

[two240s]

ok well I just measured a stock bottle cap and the wheel and they were both about 32mm across I have to be doin this wrong.

measure the hold in the back side of the wheel. I'm guessing you measured the front

[asuj158]

I measured the hole in the back where the hub goes into, i measured the diameter across

[Hick]

ive seen a number of e30S with 15" fittipaldis.... ive even got a set of 16"ers that look just like that.

centerbore is a perfect fit

[asuj158]

ive seen a number of e30S with 15" fittipaldis.... ive even got a set of 16"ers that look just like that.

centerbore is a perfect fit

thanks for the help!