Feeler: 1/2 inch Sway Bar Mounting Spacer for long tube 24v Motor Swaps

[sharksforthecup]

Bump for a homey.

I think your right and that I will need a set for my euro headers!
So save a set for me.

[m_dudey]

hey kyle, does this require you to drill a hole into the subframe where the tab use to insert into? how does the other end of the socket head cap screw get secured onto the subframe?

[m_dudey]

oh nevermind, that is the other subframe bolt

[kalib0y]

thread revival! can you still make these?

[ayemattyyy]

^ Seconded ^
Matt

[motors4me]

^ third...ed?

[giantkeeper]

I don't know what you were charging, but i'd be interested if you can get me a set before I make myself a set...

[giantkeeper]

I don't know what you were charging, but i'd be interested if you can get me a set before I make myself a set...

nevermind, I made 1/4" aluminum spacers today. Thanks!

[Chuzo]

sorry to revive the thread... OP are you still making these? or have any available?

[trackjunkie21]

I need a set.

[JGee]

When a member here needed a pair of sway bar spacers I made a few sets. These spacers will lower your sway-bar .5". Which worked to clear a set of Raceland headers. The spacers are made from lightweight 6160 aluminum.
$80 shipped


I also took these spacers a step further and made a couple of sets that mimic the profile the sub-frame mounting area. These turned out to be a bit shorter lowering the sway bar .425" which did not clear the headers. I am going to take a loss on these and let them go for the same price $80 shipped. They can be spaced down for more clearance or used as is.



If there is enough interest the plan is to make more out of thicker material to provide over .5" of clearance. The cost of the new thicker ones would be about $110 shipped.

[DaveSmed]

When a member here needed a pair of sway bar spacers I made a few sets. These spacers will lower your sway-bar .5". Which worked to clear a set of Raceland headers. The spacers are made from lightweight 6160 aluminum.
$80 shipped

I'll take a pair of the 0.5" off your hands.

[giantkeeper]

Very nice work on those spacers!

[JGee]

^^
PM sent
^
Thanks

[Mouse]

Reviving yet again....any of these available?