“Bavauto” Headers Group Buy

[delatlanta1281]

I was trying to avoid those clamps. They make it a bitch to separate the pipes later on ... I might just have it welded.

Thanks much guys! J

don't do it. think about ease of removal.

[Pocket Chant]

^Wow, that guy worked fast.

At any rate, sent $35 in! Hopefully I'll be able to get these on the car in the near future.

[Bullet Ride]

At any rate, sent $35 in!

Thank you Sir!

[tytypetersen]

Super easy installation. Also sent in that extra money.

[Bullet Ride]

Also sent in that extra money.

Thanks man :)

[TrippinBimmer]

Anthony Lam 325, mid section included, uncoated, 1 set

[Bullet Ride]

Anthony Lam 325, mid section included, uncoated, 1 set

Sorry, you'll have to wait for the next one. This one is over.

[Bullet Ride]

Just an update on the back payment situation: So far 10 out of the 20 people involved in this group buy have been gracious enough to chip in to help cover the money I lost running the group buy. The other 10 people I have yet to hear from despite having PM'ed them.

[delatlanta1281]

If you have an extra set/ sets, I would be down to buy at least one more. Just an fyi.

[e30lyf]

if you have an extra set/ sets, i would be down to buy at least one more. Just an fyi.

+ 10

[TrippinBimmer]

Remove me from List. Going with S50 Euro Swap..

[canakami]

Sorry, you'll have to wait for the next one. This one is over.

Remove me from List. Going with S50 Euro Swap..

Did you even read? Lol.

As pertinent to the thread, the videos posted sound awesome. People should post more! Hopefully I have some spare cash if this ever happens again.

[Mendi3]

Sent the extra money

Thank you again! Sorry it took me a while but I was out of the country.

[Pocket Chant]

They're currently being put on with a cat, So I should have it back tomorrow. I might do a video of it then, but I'm planning to get a Remus at the end of the month, so I might wait until then.

[e30slidewayz]

So, installed these suckers today with the midpipes as well. Sound sweeeet. However, it's idling rough bc the O2 sensor is so far back. The check engine light comes on and it stalls out sometimes at idle. O2 sensor is brand new. Once I get it going on the road, the engine light goes out and it drives fine, it just idles rough. What are you guys doing to adjust for this? Or will it just take a few days of driving to normalize? Also, I'm about to install a 3" miller MAF which comes with a new chip for 19# injectors, dunno if that'd make a difference or not.