If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I finally received mine after nearly 2 months of dealing with USPS! These look great,and I just installed them. Too bad the car will be on jacks for a couple of months
I finally received mine after nearly 2 months of dealing with USPS! These look great,and I just installed them. Too bad the car will be on jack stands for a couple of months
What do I do with the ABS sensor? Can I just remove it and leave the hole open where the actual sensor is? Or do I have to leave the sensor in, and cut the wires?
What do I do with the ABS sensor? Can I just remove it and leave the hole open where the actual sensor is? Or do I have to leave the sensor in, and cut the wires?
I'd just leave the sensor and cut the cable or maybe remove it clean it up and put some corrosion control compound in there and then seal it back on so you dont have way for water to get in there and start rusting stuff worse.
or do it the right way and make a block off plate and seal that but I mean the first option is free minus your time and this option would cost you like maybe $15 for a piece of metal to make 4 block off plates for and drill some holes.
Comment