GB: Feeler Adjustable Sway bar links

[bobross]

Is it possible that i recieved the wrong front links?

I ordered for a lowered Stock front bar and i recieved liks that look like this:

[PeaveyBassist]

Greg, thats what mine look like and I ordered the same thing.

Will

[rs4pro3]

Ya that's what they should look like, unless you ordered ix or m3 style links

[bobross]

it seems as tho my stock front bar dosent have holes in it rather the link slips over the end like the rear?

[PeaveyBassist]

it seems as tho my stock front bar dosent have holes in it rather the link slips over the end like the rear?

Stock front sway bar has one hole in it. Does NOT slip over the end of it.

Will

[rs4pro3]

Ya all the stock front's have the holes, the only car I can think of that uses a slip on link, are those sold by Ireland Engineering, but those are aftermarket.

[Axxe]

How much for M3 fronts and OEM rears?

[PeaveyBassist]

I have these and when installing today, there is a lot of play in the link between the bracket. Is it suppose to be able to move back and forth there? Or should it be tight between something there? If I could, I would like to have a picture of them fully installed.

Will

[rs4pro3]

do you have the 2 brass sleevs installed? If so just tighten down till it's tight, the bracket will bend a little, but that is ok.
Should look like this with one brass spacer on either side of the link

[rs4pro3]

How much for M3 fronts and OEM rears?

M3 fronts-$75 shipped
stock Rears-can't do unless it's a large quanity, I don't have a welder so I have to pay someone to weld them.

[PeaveyBassist]

do you have the 2 brass sleevs installed? If so just tighten down till it's tight, the bracket will bend a little, but that is ok.
Should look like this with one brass spacer on either side of the link

What are those 2 black bushing looking things on either side of the link? I have the brass things on either side on the inside of the bracket. Should I just let the bracket bend until its tight?

Will

[rs4pro3]

that one shown is one I experimented on ussing a rubber boot to seal the bearing. But ya just tighten till it's tight, the bracket will bend a little but nothing major that would decrease it's strength.

[browntown]

any more pics of installs or reviews from ppl in the last GB?

Any idea when the next GB is going down?

I'm in no rush, so just shoot me a PM when you get another GB for this going.

[rs4pro3]

I can make these at anytime for people, the cost is just a little higher, but if there is enough interest I can do another buy.