GB: Prolumen HID kit

[swimerskidude15]

I am not sure the 9006 was plug and play, the h1 u have to use adapter. Look at the picture on the first page. Do you have an AIM screen name?

[swimerskidude15]

i just emailed umnitza asking for an install guide... thats if you havent figured it out already ;) if you use the picture on the first page u can figure it out, where the red plug is on the first ballast is where the adapter plugs in which then plugs into your H1 plug. Im waiting for Umnitza's reply tho about a guide just in case.

[formula driver]

my Aim name is breytonm20.

[formula driver]

The wire with the blue connector on the end with the black and red female connectors on the opposite end, Where do these wires go? Which wires do I run from my car to the hid's, if any? Everything else looks easy enough.

[formula driver]

Im deffinatly gonna need that install guide. My ellips are diy smoked units from mike so each low is different. That and the fact that its not just a plug and play. You have to cut the back part of the ellipsoid bucket where the bulb goes.

[swimerskidude15]

well if u get on AIM my screen name is "swimerskidude15"

http://thexenonstore.com/beetleinstall.htm

look at that install guide since it is h1 and the same kit as you have. If that doesnt help umnitza is still getting some instructions for me.. another guy just put in his H1s with no difficulty. I will refer you to him so you can ask him any questions. his AIM screen name is "Katunit" and his name is Jim.

[der affe]

are these available in a "by-zenon" (high and low in one bulb) for a h-4?
greg

[der affe]

bump

[formula driver]

Just sent you a PM, one of my lights stopped working.