Torque spec for s52 main caps?

[kevmo707]

I need the torque specs for an s52 main cap in lb/ft. I read some where that the it is 50 NM, but my torque wrench's NM is in smaller numbers.

thanks

[jrdeamicis]

I could have swore it was 22Nm and than 50 deg.

[rThor432]

Centernet isnt working right now, for some reason, but that sounds right. It isnt much, at all. I want to say that the angle torque was actually a 35*, but I cant be positive without my "official info".

[rThor432]

Bump to add---

Edit--
11 11 Engine block Type Thread Tightening specification Measure

1AZ Main bearing screws
M10 / M20 / M30 M10 Replace, wash and oil screws 60 Nm
M21 M10 Replace, wash and oil screws 65 Nm
S38 / S14 / M40 / M42 / M43 / M43TU / M44 / M50 / M41 / M51 / S50 / S50 US M10 Replace, wash and oil screws
Jointing torque 20 Nm
Torque angle 50 °
M47 / M57 M10 Replace, wash and oil screws
Jointing torque 20 Nm
Torque angle 70 °
M47TU / M57TU M10 Replace, wash and oil screws
Jointing torque 22 Nm
Torque angle 90 °
M67 M12 Replace, wash and oil screws
Jointing torque 20 Nm
Torque angle 200 °
S54 M10 Replace, wash and oil screws
Jointing torque 25 Nm
Torque angle 50 °

2AZ Main bearing screws
M70 / S70 / M73 M10 Replace screws
Do not wash off screw coating
Jointing torque 20 Nm
Torque angle 70 °
M60 / M62 M10/M11 Replace screws
Do not wash off screw coating
M10/M11 Jointing torque 20 Nm
M10 Torque angle 70 °
M11 Torque angle 100 °
M54 / M56 / M52TU / M52 / with aluminum engine block M10 Replace, wash and oil screws
Jointing torque 20 Nm
Torque angle 70 °
S52 / M52 / with cast iron engine block M10 Replace, wash and oil screws
Jointing torque 20 Nm
Torque angle 50 °