If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
well, i got some of the ebay headers, and noticed each unit has a port for an o2 sensor, my question is, can i just throw the o2 sensor into one of these ports, or should i have an x pipe made up and put the o2 sensor in there...
You will be fine putting it into one of them, its just keeping your mixture right is all. If you have a custom setup made, put it in a merged section. Otherwise, dont sweat it.
Comment