Help me diagnose this problem

[BlackE30]

Yea I have the brown one in.

The problem is the blue sensor has a different thread size and is too small for the hole. Just found this out when I went to pick up a new sensor.

[jeff_b]

a decent plumbing shop should be able to hook you up with an adapter...

[416stroker]

your doing it wrong.

It goes The temp sensor to the dme goes in the first hole #14. The sender to the cluster goes in the second hole 13.



The sensor you need is this one:
http://www.pelicanparts.com/cgi-bin/...ch%20%20%20%20


Or

http://www.pelicanparts.com/cgi-bin/...ch%20%20%20%20

[BlackE30]

No, I did it right just worded my last post poorly.


The forward sensor's port on my S52 cylinder head is threaded for a larger sized temp sensor.

I got a sensor in there that works, came out of an 89 325is.

Thanks for the help.

[jeff_b]

Is it running ok?

[BlackE30]

Yea, so far so good. All I did though was start it up and let it run for about 15 minutes. Its up on jackstands getting a bunch of stuff done.

Will test it out next week when I get everything finished.

Jeff