Fault code 65?

[rede30]

I am getting a fault code 65, this code does not show up as a Peake fault code for this application. My s50 has made it's own code.

It is all with this mess.

http://www.r3vlimited.com/board/showthread.php?t=160495

[evil_twin]

"A/C PRESSURE SIGNAL
Explanation
This trouble code is stored when the A/C compressor is sensed as being switched "ON" (battery voltage on pin 65) but no A/C switch signal (0 V on pin 64) is received simultaneously.

Troubleshooting

* Check wires to the Digital Motor Electronic (DME ) control unit Pin 64 and 65 for a short and break.
* Proceed with displayed scan tool diagnostic instructions where applicable."

[rede30]

thanks. I do know have any ac components so I guess this would make sense. I wonder why I have never picked it up before and it would be fantastic if I could dummy it so it doesn't give me a cel.

[evil_twin]

I wonder if your pin out is right on your connector.

[rede30]

now I wonder. I will have to look into this.