new to me 24v is a dud..what shal i do

[Farbin Kaiber]

Call larger scale yards that will ship also. You may find the engine you desire for 200 freight from Ca.

[SpecM]

will my m50tu head fit on a s50 block and rotating assembly?

yes, just fine

[brn2ply7]

will try and get pictures up tonight. tore it down last night to the long block

[brn2ply7]

1. Well leak down test showed 35% leak down on 5, though the bottom end was almost spotless. I should be picking up a s50 short block this Sunday...So theoretically with m3 cams i can make this a mock s50 correct?

2. i am confused as to which gasket set i need to order from pelican parts if i do this..m50 gasket set OK?

3. I am still trying to keep this on a tight budget. So with that said what all should i absolutely replace? I am going to go ahead and replace the valve springs and keepers as i will run s50 cams with the s50 bottom end. Gaskets all around are obvious as well as water pump, thermostat etc... but what else do you guys believe is necessary?

Thanks guys, Zach

[jrdeamicis]

it need to matches the bore of the bottom end.

So S50 Gasket set.

Full Gasket Set, Top and bottom.

New 96+ Retainers
Valve Stem Seals (Which are in the gasket set)

[brn2ply7]

so if the bottom end is +4mm what do i use?