solid mount size?!?!

[bloodshot-e30]

allright i have the stuff to make my solid mounts i just have 2 questions...
what size height and width do they need to be
and... do they HAVE to be offset or can the hole be straight through?

[erik325i]

I don't remember the hight of mine, but they are about 1.5" in diameter. I made the studs centered. Keep in mind the top and bottom surfaces are not parrallel.

Erik

[bloodshot-e30]

I don't remember the hight of mine, but they are about 1.5" in diameter. I made the studs centered. Keep in mind the top and bottom surfaces are not parrallel.

Erik

okay thanks
if you do end up remembering the size pleas let me know! and would you happen to remember the angle?

[Fusion]

What material are you guys using for solid mounts?
It would be a great help if someone had the measurements.

[erik325i]

okay thanks
if you do end up remembering the size pleas let me know! and would you happen to remember the angle?

If I remember tomorrow, I'll measure them tomorrow. I made them just a hair under the height of the stock e28 m5 mounts, so if have a set of mounts already, use those as a reference.
I never measured the angle. I just kept shaping them until they fit.

What material are you guys using for solid mounts?
It would be a great help if someone had the measurements.

I am using aluminum.

Erik

[bloodshot-e30]

If I remember tomorrow, I'll measure them tomorrow. I made them just a hair under the height of the stock e28 m5 mounts, so if have a set of mounts already, use those as a reference.
I never measured the angle. I just kept shaping them until they fit.

ahh okayy
i was gonna make mine a little taller for th header to clear? and make the left one lightly higher than the right to help with the intake manifold


I am using aluminum.

Erik

im using either aluminum or nylon