S50 being installed, what goodies should i add?

[5ickride]

Hi-

My car is undergoing surgery and getting a new (to me) S50 motor. The motor comes with the ZF tranny, light flywheel, clutch kit, and headers. I also told them to perform a basic tune up (plugs, water pump, thermostat). Aside from this, what should i do? For performance gain or preventative damage...let me hear it. Oh yea, my engine bay is being re-sprayed and engine cover is getting some ink. ;)

[Wh33lhop]

While it's out, gaskets and seals never hurt.

[5ickride]

I think he said valve cover gasket was done also, but i'll check. thanks

[samiam3356]

Replace the gasket between the block and oil filter housing. Would suck to do it in the car if it starts leaking. Also there are two plugs in the back of the housing that have rubber gaskets around them that are cheap and easy to replace while its out of the car.

If your not doing cams and the such then everything else will be easy bolt ons for performance wise.

[5ickride]

Will bring this up...thanks