header

[Filth]

Hey guy´s...

do u all use @ M50 swaps no headers just the original M50 manifold?

I use this one...

http://cgi.ebay.de/Facherkrummer-Bmw-E34-E36-E39-E-34-E-36-E-39-/190477751726?pt=Autoteile_Zubeh%C3%B6r&hash=item2c595bd5ae

Wich one ure using?

sorry for the bad english

[Wishno87]

That is what many people use. Had them on my car till a few weeks ago.

[Filth]

any1 used the original?

[318isbmw]

I used the original manifolds for a while on my m50, the cast ones, not the obd2 ones. I got rid of them for headers eventually.

[Wh33lhop]

I still have OBD2 manifolds on my M50NV swap. They go straight into shitty crush-bent custom made downpipes then into the stock M20 catback.

It sounds pretty good from outside the car, it's maybe a tad louder than a stock M20 exhaust but you get a nice burble whenever you roll off the throttle. Too bad it's not loud enough to hear over the intake from inside the car. :(

[graphikg]

I had the m50 ones, but switched to ODB2 headers - but I probably should not have done that if I wanted to try to get my swap passed by the state ref for smog.

[rThor432]

The smog refs are really smart enough to pick up on the stainless vs. cast manifolds? Impressive.

[blunttech]

you should use this one

[Beemer-man]

Does it really fit the E30+M50 without modifications? I have also been looking at German ebay and found that m50 headers are very cheap, perhaps they are made in China?

Iam planning to use something like that with a E36 M3 catalysator.

Hey guy´s...

do u all use @ M50 swaps no headers just the original M50 manifold?

I use this one...

http://cgi.ebay.de/Facherkrummer-Bmw-E34-E36-E39-E-34-E-36-E-39-/190477751726?pt=Autoteile_Zubeh%C3%B6r&hash=item2c595bd5ae

Wich one ure using?

sorry for the bad english