hyperextended slave cyl

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Knoepfler
    Mod Crazy
    • Dec 2007
    • 631

    #1

    hyperextended slave cyl

    So I hyperextended a new clutch slave cylinder and then when I got a new one and installed it and drove the car around, there's a piece of it rattling around irregularly inside the tranny.

    What's the best way to get it out?

    Edit: and I have no idea what it is because the rod/rubber ring thing were still attached
    Last edited by Knoepfler; 04-07-2011, 01:02 PM.
  • iamsam
    Advanced Member
    • Jun 2008
    • 172

    #2
    I'd say unbolt the driveshaft, unbolt the trans from the motor, pull them apart while still in the car, attempt to retrieve parts w/ a magnet.

    Comment

    • 328ijunkie
      Forum Sponsor
      • May 2007
      • 3961

      #3
      What trans you running? Fish it outta the Oil pan bolt holes in the bellhousing

      Check Us out on Facebook
      Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
      Full Product Line Tuning
      OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

      Comment

      Working...