Need help s52 swap in Sacramento

[e30f3ver]

Hey folks! I just swapped a s52 obd1 into my e30. I have everything wired up and I'm getting nothing. I used the power distribution block from the e36 don't know if that matters. I had a harness conversion made by Nando. And all I get is dash lights on a click from abs unit but nothing cranks not even the fuel pump sounds like it's on. Any suggestions. Maybe any local guys that might
Be able to come by and take a look? Thanks!

[sticksdaman]

check your grounds, make sure the wires on the terminals on your starter are connected and tight, if you have power to the starter she should turn over.

The ground strap on the motor mount arm to the body, make sure both ends are clean and free of corrosion. I had this exact issue with my obd1 m52 a few weeks ago

[mohamadr89]

Which ecu are you using? Because I'm doing a s50 swap in my e30 with the m3 413 white label ecu. I needed to buy a ews security system delete chip. Maybe your computer has ews. If your using a red label then I'm not sure what else the problem can be...

[e30f3ver]

Using 413 red label. Checked the grounds seem to be ok.