Announcement

Collapse
No announcement yet.

dbilas cams vs us m3 cams?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    dbilas cams vs us m3 cams?

    Hello guys ...I"m looking at some options for my future build ... the engine : M52b28 ... i wanna keep it NA and make something over 210 whp ... I know almost everything about the us m3 camms and i am pretty sure its a nice mod...
    I found some sport cams at this company: DBILAS ... here is a link :http://www.dbilas-shop.com/Products/...0f5bies9ve7c66

    I have no clues and cannot find some info about what power they make ... from the specs that they give what do you guys think would they make more or less power then the m3 cams... ? I am not a tech guru so lift duration and all that doesn't mean anything to me... If someone could help with this i'll appreciate ...
    Tags: None
    #2
    On average they seem to be a bit higher duration and a bit lower lift than M3 cams (which are 252/240 duration and 10.2/9.7 lift). I don't know the M3's phasing/profile though so I can't tell you anything else about them.

    I would probably opt for some Schricks, but I'm not sure on availability in Romania. Build the bottom-end too, and don't forget to tune it!
    paint sucks

    Comment

      #3
      usuallly lower lift=regrinds=notgood.
      shricks are new castings thus them being 324234$

      Check Us out on Facebook
      Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
      Full Product Line Tuning
      OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

      Comment

        #4
        schrick's are the best ... thats what i hear ...m3's are the cheapest... but shipping is gonna be an issue i guess... these ones look ok and dbilas gives you software with them ... so thats nice to...put they are expensive... i think that in the same price i can ship m3 cams from the states...
        I also was thinking to get high comppresion pistons and port the head ... where to buy some high compression pistons ...? i have searched and cannot find a company that makes them... any input is appreciated thanks guys..:)

        Comment

          #5
          If you are going to do port work, make sure you do it right.
          paint sucks

          Comment

            #6
            Originally posted by Wh33lhop View Post
            If you are going to do port work, make sure you do it right.
            There is a company in Hungary that does port for allot of cars and they are pretty good ... they did an engine for one guy that goes 11.6 ... i posted da video of the car...:)

            Comment

            Previous template Next
            Working...
            X