S50 w/ ZF 5 speed DSSR options?

[craiggroves91]

I'm looking into purchasing my shifter setup for my s50 e30 with the ZF 5 speed.

I'm going with the AKG quickshifter 2.
My main question is what selector rod do I want?

Do I run the e36 m3 selector rod?
I want to run a DSSR

Will the akg e36 m3 DSSR and the AKG quickshifter be good to go?
thanks
-Craig

[eurosport22]

what driveshaft are you usnig. i had the rogue ssk with my s50 zf and i used the revshift aluminum guibo for the 24v swap so i could keep my stock driveshaft and there was interference between the dssr and the guibo. i had to revert to the z3 shifter i had witht the factory motor and trans because it was a little shorter. sorry i cant be of any more help to your exact application but i figured it would be nice to know about the issue i had. the only place it would hit was reverse and 1 and 2. everything else was on but the angle when the shifter would rock over was enough to make it hit.

[craiggroves91]

what driveshaft are you usnig. i had the rogue ssk with my s50 zf and i used the revshift aluminum guibo for the 24v swap so i could keep my stock driveshaft and there was interference between the dssr and the guibo. i had to revert to the z3 shifter i had witht the factory motor and trans because it was a little shorter. sorry i cant be of any more help to your exact application but i figured it would be nice to know about the issue i had. the only place it would hit was reverse and 1 and 2. everything else was on but the angle when the shifter would rock over was enough to make it hit.

Didn't think about that. I'm probably going to run the early model 325e driveshaft. Not sure yet.
I forgot about it hitting the guibo