Announcement

Collapse
No announcement yet.

Swap 1/4 Mile Thread

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • aeryk7
    replied
    What rim and tire combo are you running ? You put up a pretty decent 60ft

    Leave a comment:


  • tonytony
    replied
    i have yet to try my luck at the strip, next year though we'll see.

    Leave a comment:


  • ed94r
    replied
    I went up to the drag strip (Va Motorsports Park) with a few friends and in 5 hours only managed 3 runs...had some wheelspin issues and had to back pedal the gas a bit on launch (launching from about 2.5K).

    Best was my third run:
    R/T .143
    60' 2.055
    330 5.840
    1/8 8.949
    MPH 80.09
    1000 11.596
    1/4 13.840
    MPH 100.66

    Unfortunately, shifting to 4th before the lights leaves me "off the cam" thru the lights. It comes on the cam about 105mph, so I'm a sitting duck at 95-100 mph where I've got a nice dip in the power curve. I may play around with cam timing, or just bite the bullet and Schrick it.

    Had the honor of the quickest BMW there. A guy was hacking it up in an E46 M3 (13.9 on race rubber!) and another fella in an E39 540i (14.7).

    It was Fun.

    Ed

    Leave a comment:


  • aeryk7
    replied
    E30 S50 - 1/8th Mile

    60ft - 2.019
    1/8th - 8.6
    mph - 83.4

    Mods: Ebay Chip, Intake, OBD1 Center section ,No Muffler

    --------------------------------------
    Check Engine code : Bad Air Flow Sensor

    1/4 mile

    r/t .042
    60' 2.103
    330' 5.818
    1/8 8.77
    mph 82.97
    1000 11.345
    1/4 13.4
    mph 103.31

    Not really enjoying not breaking 2.0 60ft times oh well 195's and wheel hop own me not to mention negative camber

    I want a 12.9 damnit ,the LS2 GTO that i ran on the street ran a 13.0 with a 2.0 60ft . I pull on him in third gear.
    Last edited by aeryk7; 11-12-2006, 05:01 PM.

    Leave a comment:


  • Brew
    replied
    60' ... 2.199
    1/8 ... 9.015
    MPH ... 81.60
    1/4 ... 13.857
    MPH ... 101.14

    S50, 260, 3.73lsd, euro hfm, 24# inj, Conforti sw

    Leave a comment:

Working...
X