M3 Wire Harness Cover

[mtlbloodshot]

I just want to know who has ran into clearance issues with the M3 Wire Harness Cover. When I place my intake manifold, it instantly comes into contact with the main support and then if I wanted to get the cover on, that would also hit the manifold. I read that it needs to be trimmed down but any one have other solution or maybe possibly the correct way to trim it?

Thanks

[blackhawkimpact]

You need to trim by were it hits on the manifold. Lower left side.

[mtlbloodshot]

Anybody else have a idea

[SHunter]

I trimmed mine by marking it with a sharpie and then pushing it against the bench grinder a little at a time until it matched up to the manifold with a few mm to spare. You can do a nice clean job this way or maybe even with a dremel if you have a steady hand.

Other option...shorter engine mounts??

SH