Is my DME mounted correctly??

[bimmer630]

check out my build thread.. I had to stretch my DME harness to get the bracket to mount up inside the glovebox. Would be much better if the dme was upside down

http://www.r3vlimited.com/board/showthread.php?p=3550856&posted=1#post3550856

[Boise]

I think you need to go one more notch further back like below, although it looks like you have an AC line behind, not sure if that will cause clearance issues.


Picture taken from cjdontthink's thread here: http://www.r3vlimited.com/board/showthread.php?t=266738

[bimmer630]

Yeah man there's no room. I was just curious if I had the whole arrangement correct on the brackets

[woc]

My harness would never reach that far, it's so short it's redonculous. Im going to have to fabricate something to have it attached somewhere in there.

[328ijunkie]

E34 harness FTL
;)

If you open up the wire 'box' in the center you can cut some zip ties and buy yourself another half inch.

[bimmer630]

In order to get the diagnosis connector in its correct holder I had to Yank everything to the drivers side.. if I made a custom mount on the r/s strut tower area it would all work better I think

[328ijunkie]

[bimmer630]

you have the c101 in the round mount on the drivers side?

[328ijunkie]

Dont use it :P. I put the C101 under the 318 covers in its factory mount: