S52 in a E30 M3 help

[ibcutinup]

I have been searching info and I have found bits and pieces but I'm looking for a CORRECT AND COMPLETE parts list to do the S52 swap in my M3. I find sites with some parts on it but some sites give totally different parts than others. If someone has a list can you please send this to me ANIAH605@aol.com I would greatly appreciate it. I'm new to the forum, but if anyone is having trouble locating parts I am the sales manager at a Salvage yard in VA we have a few BMW's there and I have access to 100,000 other junk yards in the US. I was also wondering if I can use my Borla exhaust with the S52 swap or does anyone know what sounds good with the swap. I dont want something ricey sounding, I like the deep, throaty sounds but also not to loud like BB. Again thanks for your help.

Mario

[equate975]

http://jokesanonymous.com/e30/swapparts.htm

Thats the majority of the parts I used in my swap.

I Just ordered up parts for my exhaust, I am going to run two 2.5 inch pipes going to magnaflow cats and a D/D 2.5 muffler.

You could use the borla, I have one also. I would imagine you would have to cut it pretty close to the auctual muffler and probably widen the pipes to it. I figured I would just pocket the $400 from it and invest in something better

Parts alone for my exhaust was only $200, putting it together (shop doing it) I think will be at most another $200.

Full exhaust in exchange for a muffler. Seems like a good trade to me :)

[equate975]

Oh I used the wrong slave cylinder too, use the e36 in an e36 tranny.

And I blew my master up

Replace them both, apprently you are supposed to do them both at the same time or not at all. Otherwise you will keep blowing one up.