TDC on an engine stand

[f4tj0n]

How can you make sure the bottom end is at tdc if you are assembling the motor on a stand?

Started doing the timing last night but wanted to ask for advice before proceeding.

thanks!

[f4tj0n]

I have the alignment mark lined up, but I'm thinking its not precise enough for TDC.

[MyE30]

the notch in the flywheel for the holding tool still allows some play. i've used the holding tool and just the alignment mark on the timing cover; both worked just fine.

[mpowerful]

Use a long dowel rod (i used a giant zip tie) and put it in #1 cyl through spark plug hole. Turn till its at the top. Check timing marks.