M52 oil pressure light hangs around after starting

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Gruelius
    Wrencher
    • Oct 2009
    • 298

    #1

    M52 oil pressure light hangs around after starting

    Hi all,

    When I start the m52b28 if it has been sitting for a few days it takes around 2 seconds for the oil light to disappear. Is there a drainback valve or something that might have failed?

    It runs quite well, but it had been getting 15MPG cause of a huge vac leak (plastic valvecover had a chunk missing under one coil pack) and a bad ecu while the P.O. had it so it might be a bit worn. Engine and car was also not looked after by past owner

    Thanks.
    RIP 84 323i coupe 5spd w/ 14psi
    89' 318i
  • 328ijunkie
    Forum Sponsor
    • May 2007
    • 3961

    #2
    The two orings on the oil filter housing cap need to be replaced.

    Check Us out on Facebook
    Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
    Full Product Line Tuning
    OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

    Comment

    • Gruelius
      Wrencher
      • Oct 2009
      • 298

      #3
      Sweet, makes sense. The filter kits I got for the m52 only came with the larger oring, will get the lower one separately in my next parts order.

      Thanks!
      RIP 84 323i coupe 5spd w/ 14psi
      89' 318i

      Comment

      Working...