Announcement

Collapse
No announcement yet.

No Injector Pulse!???

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    No Injector Pulse!???

    I was driving my e30 m52 swap and slammed on the brakes and the car suddenly shut off. I was low on fuel so I put more in the tank still no start. I jumped the fuel relay and it fired up then died. I put the relay back in and got it running and drove it home no issues. Let it sit for an hour and it wouldn't start. I assumed the pump was going bad so i put a new one in it and still no start. I have no injector signal but there is 12v to each injector. I have spark and compression and it will run on starting fluid. I tried jumping the fuel pump again and now it won't turn the pump on and i only have .4VDC at the main and fuel pump relay. Fusible link is good. The battery ground appeared to come loose when I slammed on the brakes could that have fried anything? Any help is appreciated I'm almost ready to sell this car.

    #2
    Check ground wire at front of.motor, I hit a hole in road and mine broke, there super.brittle


    Please leave feedback below, thanks

    http://www.r3vlimited.com/board/showthread.php?t=358170

    Comment


      #3
      Check cam position sensor.

      Comment


        #4
        bad cam sensor just batch fires injectors, will still run fine for the most part. I would look at harness power/ground, engine ground and crank sensor.

        Check Us out on Facebook
        Needing a harness adapter or wiring help? Check it out: also have 24v motor mounts, E30 M3 covers and E36 ECU mounts!
        Full Product Line Tuning
        OBD2 Tuning Available! OBD2 E36, S54 Swap, S62 Swap, etc: tuning@MarkertMotorWorks.com Dyno Thread

        Comment


          #5
          If it's not ground related, I would try getting your hands on another DME.

          Comment

          Working...
          X