If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am using the revshift 24v motor mounts, and I want to note that OBD1 m5x downpipe fits perfectly with no hammering. It cleared by bigger sways, subframe, and stock lollipop WITH the metal heat shield around it. I was pretty surprised.
I am also using obd2 headers. just a FYI for anyone out there
Can you please send me a pic underneath your car? I have the revshift mounts and the bank 1 header gets too close to the subframe. Tried obd1 and obd2 manifolds but no luck
Comment