Hey all,
My setup is M20 singlemass flywheel, M20 starter, M20 clutch and pressure plate, M20 325e throw out bearing (came from my singlemass 325e), ZF Transmission.
My understanding is that the clutch engagement point will be low using the 325e/i TOB. Will it be low enough that it'll be annoying, should I just swap it out while I'm still putting my car together? Thanks.
My setup is M20 singlemass flywheel, M20 starter, M20 clutch and pressure plate, M20 325e throw out bearing (came from my singlemass 325e), ZF Transmission.
My understanding is that the clutch engagement point will be low using the 325e/i TOB. Will it be low enough that it'll be annoying, should I just swap it out while I'm still putting my car together? Thanks.
Comment