No o2?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • cahomey
    E30 Fanatic
    • Mar 2004
    • 1201

    #1

    No o2?

    Some how my o2 sensor connector unscrewed itself from the harness and broke hitting the ground, so now I can't keep them connected without tape or and new o2 sensor.

    My question is, I just drove 2 1/2 hours north with no o2 sensor. Is this a problem? Am I running my motor to rich? Will my cat be owned? I plan on fixing this when I get home.

    :drink::drink::drink::drink:Chico, ca - party town ftmfw biznitches,

    "It's like a koala bear crapped a rainbow in my brain."
    R.I.P. Harry Goz aka. Captain Murphy
    "My ride, My ride, she don't beg, steal, cheat, or lie,
    My ride, My ride, and our relationship is classified."
  • cahomey
    E30 Fanatic
    • Mar 2004
    • 1201

    #2
    20 views wtf?

    "It's like a koala bear crapped a rainbow in my brain."
    R.I.P. Harry Goz aka. Captain Murphy
    "My ride, My ride, she don't beg, steal, cheat, or lie,
    My ride, My ride, and our relationship is classified."

    Comment

    • NZM50SWAP
      Member
      • Feb 2006
      • 75

      #3
      Should be sweet cuz.

      When I did my swap a year ago I didn't even connect mine up at all. only in the last couple of months had I even learnt about a o2 sensor. My car runs fine as all the time.. No cat just straight through exhaust as we don't have emissions control in NZ

      Comment

      • f u z z
        E30 Mastermind
        • Jul 2004
        • 1600

        #4
        i dont run one, nevr have. car is fine

        Comment

        • cahomey
          E30 Fanatic
          • Mar 2004
          • 1201

          #5
          Doesn't the check engine light get annoying to look at?

          "It's like a koala bear crapped a rainbow in my brain."
          R.I.P. Harry Goz aka. Captain Murphy
          "My ride, My ride, she don't beg, steal, cheat, or lie,
          My ride, My ride, and our relationship is classified."

          Comment

          • tonytony
            Knee deep in poopie
            • Jan 2004
            • 3498

            #6
            wouldn't not having a functioning o2 sensor spew more fuel into the chamber and foul out the spark plugs?

            Comment

            • cahomey
              E30 Fanatic
              • Mar 2004
              • 1201

              #7
              Yea, I'm pretty sure your motor isn't supposed to be running in closed-loop all the time. It's too rich.

              "It's like a koala bear crapped a rainbow in my brain."
              R.I.P. Harry Goz aka. Captain Murphy
              "My ride, My ride, she don't beg, steal, cheat, or lie,
              My ride, My ride, and our relationship is classified."

              Comment

              • NZM50SWAP
                Member
                • Feb 2006
                • 75

                #8
                What do you mean my ( running in closed loop?)\

                I'm running custom extractors with 2 1/2" stainless exhaust
                Custom induction and chip....

                I haven't even seen a wire that comes off the loom for the o2 sensor??

                Comment

                • Mike B.
                  E30 Modder
                  • Jan 2006
                  • 987

                  #9
                  The DME needs the O2 sensor to determine if the engine is running lean or rich and then takes this signal and makes the proper adjustments.

                  If you are running without an O2 sensor, you are running in open loop, which is usually very rich and reserved for cold start conditions when the O2 sensor is not heated up completely. It has nothing to do with your exhaust setup.

                  Running without an O2 sensor probably won't damage your engine, but it will eventually damage your cats. It may seem like your engine is running perfect, but it's not because you are not taking advantage of the ability of the DME to make corrections.

                  Do you have access to a wide-band O2 sensor (e.g. LM-1)? I'm curious to see what AFR's you'll see without an O2 sensor.

                  The wire for the O2 sensor is a 4-prong round screw-on connector that is on the same portion of the loom as the back-up light connector (2-pin connector).

                  Comment

                  Working...