If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
- Tranny and drive shaft from my job- $250.00. Tranny from a 95 325, drive shaft from a m3
95 325 has a Getrag 250 with a 78mm bolt circle diameter output flange, which will not mate up to the input flange of an M3 driveshaft, which is 96mm. You'll have to either swap the output flange on the Getrag 250 or use a E36 325 manual driveshaft.
Originally posted by whysimon
WTF is hello Kitty (I'm 28 with no kids and I don't have cable)
Comment