Quick question.

[loonibab325i]

I tried searching, and had no luck, can anybody please show me how the "Evaporative emissions valve" looks like? I'm in the process of wiring up the car now, I know you connect the "BRN RED/WHT" plug to it, but I have no clue what this piece is.

Thanks in advance,

-Abe.

[kroberts]

Abe, come over and I'll show it to you.

kr

[loonibab325i]

Also, does anybody know how to tell how the knock (ping) sensors connect to the wiring harness? I know they are the same part # but i know from the wiring harness 1 plug determines if the motor is knocking in cyl 1-3 or cyls 4-6.

Also, what did you guys do with #'s
7
10
and how did you guys end up routing the vacuum lines? I know it might be hard to explain but i'm very lost now, and this is all that is holding me back, thanks guys.


-Abe.

[loonibab325i]

I also have the following wiring done

oil pressure sensor BRN/GRN or BRN/GRY
front coolant temperature sensor (ECU) BRN/RED BRN
rear coolant temperature sensor (Gauge Sensor) BRN/YEL BRN/VIO
cam position sensor YEL RED/WHT BRN/ORG
VANOS solenoid RED/WHT GRN/BLU
throttle position sensor (TPS) BRN BRN/BLK RED/YEL
intake air temperature (IAT) sensor BRN GRY
idle control valve (ICV) WHT/YEL RED/WHT WHT/GRN
crank position sensor YEL BLK NCA
Evaporative emissions valve BRN RED/WHT

still need to know the knock sensor orientation and this following sensor, the wiring colors are Green/white blue/white.

thanks,

-Abe.

[loonibab325i]

I tried searching, and had no luck, can anybody please show me how the "Evaporative emissions valve" looks like? I'm in the process of wiring up the car now, I know you connect the "BRN RED/WHT" plug to it, but I have no clue what this piece is.

Thanks in advance,

-Abe.

NVM, i stopped by Kroberts house, and he set me up square. cool guy! his swap + e30 m3 is tits!!

Anyway, if anybody can answer my questions posted above that would be cool!

-Abe.

[loonibab325i]

anyone? please? hah.

-Abe.