Im busy freshening up my bottom end on my s50b32 and found that one conrods size is a bit funny, its fine on the sides but bigger towards the centre (on the big end).
i want to change them all but cant seem to find 3.2 rods and they obviously cant be resized.
which rod would work in its place, the 3.0l rod is slightly longer so pistons stick out slightly, i suppose this can be machined but would this be advisable???
please help
i want to change them all but cant seem to find 3.2 rods and they obviously cant be resized.
which rod would work in its place, the 3.0l rod is slightly longer so pistons stick out slightly, i suppose this can be machined but would this be advisable???
please help