Need help identifying some E30 S54 swap harness connectors

[synergy141]

Hi, I'm in the middle of wiring my e30 s54 swap and I was hoping someone could help identify some of the wiring connectors I have left. I'm using Andrews PnP harness.



This teal connector has two wires cut from it. Should I keep them as is or wire them somewhere???


Also trying to figure out which terminal on the starter is "30 H"???



Two random connectors near coolant res



Another two random ones




Thanks!

[diesekte]

Pic 1 is ebox fan that cools ECU. If you put ECU in the cabin you don't need this

Pic 2 I don't think you need the 2 cut wires on the left. Mine only has the 2 black wires on the right

The three red random ones all coalesce together into a plastic plug that is female x3 for them all to fit into. I think when you buy the harness it comes shipped attached the red "random one" you have in the last pic.


I don't remember which one is the 30h terminal and I would have to take my intake manifold off to see where I put that wire...also the yellow "random one" I believe goes to the E46 M3 fuel pump relay and the eyelet goes to 12v. I would email Andrew and ask him to take a look at this thread.