Announcement

Collapse
No announcement yet.

325ix transfer case diagram parts explosion

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    325ix transfer case diagram parts explosion

    so looking to pull my TC and reseal all the seals between it and the trans but, cant find a parts explosion diagram to know what seals are specific and i need to know what to order.

    #2
    Part#########QTY######Part #

    Input seal ##### 1###27-21-1-224-632
    Front output#### 2###27-24-1-224-660
    Rear output #### 1###27-21-1-224-636

    Comment


      #3
      [/SIGPIC]"we are so totally screwed!"

      Comment


        #5
        Transfer case mount replacement

        Does anyone have any info or method to replace. The transfer case /trans mount
        Is a special tool a must or anyone done it ?

        Comment


          #6
          Is your tc auto or manual?

          Either way check this link.

          Comment


            #7
            Input shaft seal

            I'm gonn drop my t/c tomorrow . If I am gonna change my input shaft seal what is it gonna take ? Remove input drive flange and remove and install seal ? Is there a nut on the flange ? If so does anyone know the mm size ?

            Comment


              #8
              I have the 1 input seal now . but now I'm seeing there are two input seals ? Inner and outer ? Is that correct ? The diagram shows one seal but the photo breakdown link shows and talks about two seals ? Inner and outer

              Comment


                #9
                Is your tc auto or manual?

                Comment


                  #10
                  Auto

                  Comment


                    #11
                    There are two input seals on an auto tc.

                    Comment

                    Working...
                    X