If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hey guys, I need to replace my driveline/U-joint. I see Turner has a remanufacture one for $571 . . . can anyone else point me in the direction of a better/more economical route? Or is this the best way to go? Thanks!
Hey guys, I need to replace my driveline/U-joint. I see Turner has a remanufacture one for $571 . . . can anyone else point me in the direction of a better/more economical route? Or is this the best way to go? Thanks!
Where are you located, Driveline Services will rebuild them, they send you a rebuilt in a tube and you send yours back or something to that effect. I know there used to be one on Portland Oregon, might try googling them.
Where are you located, Driveline Services will rebuild them, they send you a rebuilt in a tube and you send yours back or something to that effect. I know there used to be one on Portland Oregon, might try googling them.
Sent from my SM-G360V using Tapatalk
I'm in Boise, Idaho. I will look into Driveline Services to see what I can find out. Thanks! Any other suggestions out there?
Where are you located, Driveline Services will rebuild them, they send you a rebuilt in a tube and you send yours back or something to that effect. I know there used to be one on Portland Oregon, might try googling them.
Comment