If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No, the whole intention of that thread I posted was to see how much I could get for it if I did sell. At the moment, it's not for sale because it's my only car...however, that could change in a few months.
Josh, I just got pumped up when I saw the prices and everything. Then I clicked the home page and saw that I can't buy from there....lol :( Thanks for the link, big help. ;)
Josh, I just got pumped up when I saw the prices and everything. Then I clicked the home page and saw that I can't buy from there....lol :( Thanks for the link, big help. ;)
I don't think those are retail prices anyway, I'm pretty sure that's the dealer cost
Just posted this on the other thread about these skirts, but thought I'd add it here too.
Since these skirts are so hard to get and expensive, why doesn't someone reproduce them for less. For those of you that work with fiberglass, kevlar, etc, it's as simple as getting a sample set, making a mold off of them, and them laying up copies en mass. Personally, I don't work with composites like this, but, if I had access to a pair of these skirts, I'd probably like to give it a try. Also, it's likely that someone could make some easy money by taking a set to a professional place and having them reproduce about 25 sets - make them one peice. If someone does this, just be sure to research mounting points and easy installation. Just a few ideas.
Comment