If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
with a clean install and matching body parts i think it could look good. some IS and similar skirts dont go down far enough IMO, leaving the side looking funny with a larger front lip.
Came across this topic on a Google search of SRS-Tec B1 skirts as i was hoping to find some car in the world other than that demo car running them!
i also came across these skirts just recently...i think they do look pretty cool. its hard to tell on the Cab though because it has that black rubber OEM strip thing along the bottom just above the skirt. i think without that the skirts would look even bulkier/boxier because they jutt out a fair bit...
postage will probably hurt me over in Australia, but i think the pricing on the SRS-Tec site is inclusive of VAT tax which is like 19% so it may offset post, i'll see. I also asked them about how exactly they fit, to which they replied they glue to the vehicle. I also asked what the height of the skirt is and they said 13cm.
I'm with Stephen on these- i am not entirely convinced i like the look of the IS Lip and the IS skirts, since the skirts are thinner than the lip. i want a skirt that will match in depth since the front Lip will be the thing copping the sh*t and if the lip is that low then the sides may as well be that low too and it'd look tougher then :P!
I am waiting on a confirmed shipping cost from SRS-Tec before i make a decision, in the meantime i'll keep looking for more pics, maybe on yahoo germany or something haha
Comment