Adjusting rear euro bumpers

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Schneider325
    No R3VLimiter
    • May 2004
    • 3818
    #1

    Adjusting rear euro bumpers

    This is a question to anyone who has installed European bumpers.

    Ok, I already drilled my two wholes needed to mount the back piece. I made the wholes big enough so there will be room for getting the bumpers perfectly flush with the body.

    So the very back is fine, but when I bolted on the two sidepieces something is wrong. The driver’s side isn’t that far off, but on the passenger sidepiece is sticking way out from the quarter panel.

    I'm not sure how this could be since the driver’s side is nearly perfect (probably just needs the end cap screw put it to make it perfect). My guess is the bracket is bent out of shape, but its very hard to notice.

    Has anyone else had this problem when installing their bumpers?
    Tags: None
    • NickP
      Wrencher
      • Feb 2004
      • 257
      #2
      Is the middle piece aligned / centered?
      When I installed mine I started with this piece - I used the rear center panel seams below the taillights as a reference point. Once you get this centered / height adjusted you can proceed to the side pieces.

        Comment

        • Schneider325
          No R3VLimiter
          • May 2004
          • 3818
          #3
          Originally posted by NickP
          Is the middle piece aligned / centered?
          When I installed mine I started with this piece - I used the rear center panel seams below the taillights as a reference point. Once you get this centered / height adjusted you can proceed to the side pieces.
          I'm pretty possitive everything is aligned.

          I had to take the center off thought to get the sides on. I think im going to take them off and check with just the center piece again.

          thanks

            Comment

            • Schneider325
              No R3VLimiter
              • May 2004
              • 3818
              #4
              turnes out the brackets are bent. The more I try and straighten them the worse it gets.. werd

                Comment

                • kencopperwheat
                  King of Kegstands
                  • Oct 2003
                  • 14396
                  #5
                  Post some pictures. We'll be able to help more.
                  Originally posted by Gruelius
                  and i do not know what bugg brakes are.

                    Comment

                    • NickP
                      Wrencher
                      • Feb 2004
                      • 257
                      #6
                      Originally posted by Schneider325
                      turnes out the brackets are bent. The more I try and straighten them the worse it gets.. werd
                      If the brackets are bent then I guess its not centered. Having done this I found it easy once you had the centre aligned. You first need to make sure its centered between the taillights (again, I used the panel seams below the taillights as my guide). Once you have this done you should make sure the depth is correct.

                        Comment

                        • Schneider325
                          No R3VLimiter
                          • May 2004
                          • 3818
                          #7
                          ya I'm using the lines running below the tailights. I might just get new brackets If i can't get them straight soon

                            Comment

                            Previous template Next
                            Working...