Advice need Wax Application

[MattBimmer]

Guys just wondering if anyone one had tips or advice on how to use
ARMOR ALL EXTREME SHIELD syn wax. I applied it the same as I do my meguiars wax.... and it leaves streaks that are visible.... BUT it does protect from dirt and shizz amazing.

Am I using to much? or is this stuff just fickle to work with?

[Bimmerguy91]

Try a little more elbow grease and a better microfiber when removing the wax.

[StealthiE30]

Try a little more elbow grease and a better microfiber when removing the wax.

This, and make sure to use a clean side of the MFT for each body panel. Otherwise your just spreading around whats on the MFT.

[Vivek]

Based on what you said you're probably using too much wax. I've done stuff like this before and if you apply certain waxes and sealants wrong (too thick) no amount of MF buffing will fix it.

[bmwstephen]

Based on what you said you're probably using too much wax. I've done stuff like this before and if you apply certain waxes and sealants wrong (too thick) no amount of MF buffing will fix it.

as in it'll be forever stuck on the panel???

[Mr. Tasty]

put multiple coats of the wax on and it will make it look less obvious.

[Bimmerguy91]

[/B]

as in it'll be forever stuck on the panel???

no you can strip all the wax off the car by washing it with dish soap. make sure you properly wax it again after though because your car will be left with bare paint with no protection