My current setup is a stock 1990325iC with DB's. I have the full stock bumper swap primed and ready to install. From my understanding, this is a direct bolt on application.
What I need to do is figure out what to do with the rear apron and side skirts. I've researched the issues with full DTMFiberWerkz kits, but I was curious to know if the rear apron is a different story and is an easier fit. The one I've been looking at is the M-Tech II for $225.
For the side skirts, Abrahams has Reiger parts for $259.
DTMFiberWerkz has M-Tech II skirts for $245.
Does anyone have experience with the apron or side skirts? If so, how was the fit and install? I would have a shop do this for me.
Also, any input on appearance would be appreciated. What combos do you think would look best? I'm also open to any other suggestions.
Thank you
What I need to do is figure out what to do with the rear apron and side skirts. I've researched the issues with full DTMFiberWerkz kits, but I was curious to know if the rear apron is a different story and is an easier fit. The one I've been looking at is the M-Tech II for $225.
For the side skirts, Abrahams has Reiger parts for $259.
DTMFiberWerkz has M-Tech II skirts for $245.
Does anyone have experience with the apron or side skirts? If so, how was the fit and install? I would have a shop do this for me.
Also, any input on appearance would be appreciated. What combos do you think would look best? I'm also open to any other suggestions.
Thank you