If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm talking about the trim that runs on the face of the euro/diving board bumpers. I just got some euro bumps and would like to clean them up (wet sand and such). What is the best process to clean these up?
Thanks
so does the plastic need to be sanded at all? I am interested in painting mine
You could give it a light sanding if you want to, to give it a little more adhesion power, but it's really not needed, SEM is forumlated to stick very well. I just cleaned my plastic trim really well with soap and water, then wiped it down with acetone, and painted.
Dupli-Color makes a good bumper paint as well. You can usually find it at Pep Boys or Auto Zone. It also has a good flex agent in for good rubber or plastic adhesion.
I used dupont satin black all over my car from the spray can and it is alittle bit cheaper than SEM but just as good quality. I havent had any problems with either SEM or Dupont products at all.
Comment